Static structures (e.g. – buildings) – Preassembled subenclosure or substructure section of unit or...
Reexamination Certificate
2000-04-28
2002-01-01
Callo, Laura A. (Department: 3635)
Static structures (e.g., buildings)
Preassembled subenclosure or substructure section of unit or...
C052S079500, C070S104000, C049S394000, C109S00100R, C109S05900R
Reexamination Certificate
active
06334278
ABSTRACT:
BACKGROUND AND PRIOR ART
For dangerous storms such as tornadoes, safe emergency shelters are needed to protect persons and property from harm and destruction. Tornadoes are normally seasonal with the months of March through June being the most active. Approximately twenty percent of all tornadoes occur during the months of July through October, and less than ten percent occur during November through January. Tornadoes have been recorded with wind speeds of over 300 mph and can stay on the ground for over one hour. Flying debris can cause much injury and destruction. In recent years, more than 1,000 twisters have killed in excess of one hundred twenty people and caused millions of dollars in property damage in the United States. The dollar figure for the damage caused by tornadoes which have struck Oklahoma City, Okla. in May, 1999 alone has exceeded more than 90 million dollars. Regardless of catastrophic damages that occur from tornadoes, hurricanes, and other hazards, relatively little protection against them is provided because of variously prohibitive problems with present protection alternatives. Thus, there exists a need for emergency shelters.
When tornado type warnings are issued, there is usually very little time for individuals and families to go to community shelters. Also many community shelters do not allow for pets.
The National Tornado Forum has announced an effort to encourage more people to build “safe rooms”(emergency shelters). The Federal Emergency Management Agency(FEMA) and the Federal National Mortgage Association(Fannie Mae) have programs and financing in place the encourage people to put their families in “safe rooms” (shelters). The average family moves approximately every seven years. Thus, reusable shelters would be desirable.
A variety of emergency shelters previously have been pre-manufactured for field uses constructed of cement, steel, fiberglass and other materials. Others have been manufactured in an assembled condition for particular applications. None of these prior art shelters can be site-assembled from matching parts and possess the ability of being moveable or relocateable to another address, should the owner decide to relocate, as this invention.
U.S. Pat. No. 6,003,271 to Boyer et al. describes a pre-case security vault device that includes components that can be transported to a construction site. However, this device includes the assembly of permanently affixing the components together such as by using permanent fasteners such as “welds”, and the pouring of “concrete” for floors, and the like, and nonremovable fill such as “grout” at the site, column 1, lines 37-38, column 2, lines 66+, column 3, lines 1-10, 12-25, 60-65, column 4, lines 2-4, 37-43. No where does Boyer et al. describe, nor suggest being able to easily disassemble the vault to be able to be relocated at subsequent sites. Additionally, no description, nor suggestion is given in the Boyer “vault” for ventilation purposes to allow humans to be sheltered therein. While Boyer mentions that it may be desirable in the background section of the patent to “protect property from damage or theft or to serve as a shelter . . . ”, column 1, lines 4-7, the Boyer “vault” device requires that there construction forms a “vapor-tight enclosure . . . and . . . preventing water from seeping into the vault to damage the property in the vault”, column 3, lines 14-18. Thus, Boyer is primarily used for protecting property and not as a “shelter” for people.
SUMMARY OF THE INVENTION
The first objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be produced at a minimal cost to merit its need.
The second objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be made from a variety of materials such as carbon steel, stainless steel, aluminum, and the like.
The third objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be structured for protection against a wide selection of hazards;
The fourth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be marketed either assembled or unassembled.
The fifth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be packaged for low-bulk, inexpensive and convenient transport.
The sixth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be assembled by inexperienced persons.
The seventh objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be made in sizes to meet different use requirements.
The eighth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be used for storage of food and water to meet disaster needs.
The ninth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be disassembled and transported to new location should the owner move.
The tenth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be tested and certified to withstand hazards.
The eleventh objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be used as an annex to a building.
The twelfth objective of the present invention is to provide an easily assembled and relocateable shelter for protecting persons from dangerous conditions such as storms that can be positioned inside of a garage/carport and have plenty of room between the shelter vehicle(s) stored inside the garage/carport.
A preferred embodiment of the relocateable shelter includes a rectangular frame formed from longitudinal L-shaped members that can be fastened and unfastened together, panels that can be attached and detached about the frame to form walls and a roof to the frame, and a door that can be attached to one of the walls of the frame for allowing access to an interior of the frame, wherein the frame, panels and door form a shelter allowing persons to seek safety within the shelter. The shelter can be attached to a rectangular concrete foundation beneath the shelter. The shelter can have dimensions of approximately 94 inches long, by approximately 27.5 inches wide by approximately 80 inches in height, and be formed from suitable strong materials such as ¼ inch carbon steel plates. The door can be attached to the shelter by a hinge having a step shaped hinge guard for bracing the door to a closed position adjacent to the hinge. Up to four or more slideable latches can be used to lock the door, where the latches can be accessible to both outside and inside of the shelter to open the door from a closed position. The latches can each include an elongated bar that having one end that slides inside of the shelter to lock the door, and have an outer end having a handle for allowing the door to be opened from outside of the shelter.
The latches can further include a bracket on an inside wall of the shelter for guiding the bar, and a slot in the side of the door for allowing the one end of the bar to pass therethrough so that the door is put into a locked position.
This invention makes it possible for a person, family or other group to have a place of security readily available on t
Callo Laura A.
Law Offices of Brian S. Steinberger
Steelco Incorprorated
Steinberger Brian S.
LandOfFree
Tornado safe room does not yet have a rating. At this time, there are no reviews or comments for this patent.
If you have personal experience with Tornado safe room, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Tornado safe room will most certainly appreciate the feedback.
Profile ID: LFUS-PAI-O-2838006