Method of making tubular units for the oil and gas industry

Details Method of making tubular units for the oil and gas industry Method of making tubular units for the oil and gas industry

1985-12-09

1987-12-01

Dean, R.

Metal treatment

Compositions

Heat treating

148127, C21D 908

Patent

active

047102454

ABSTRACT:
A method of making tubing and pipes for conduction in the oil and gas industry or for use as drillpipes, wherein such tubing is connected at both ends with connector sleeves by means of welding, the welding seam being deburred thereafter. The steel used for the tubing, pipes or drill pipes as well as for the connector sleeves has the following composition, all percentages by weight, between 0.2 and 0.6% carbon, between 0.5 and 1.8% manganese, between 0.5 and 3.5% combined chromium and molybdenum, not more than 0.2% phosphorus and not more than 0.005% sulphur. The combined unit of tubing and two welded on connectors is heated to a temperature which is at least 50 but not more than 200 degrees Centigrade above AC3; quenched from this temperature down to a temperature of at least 200 degrees Centigrade below AR1, tempered at a temperature below AC1, and cooled in non-moving air, to obtain the following properties: yield strength between 515 to 760 N/square mm, tensile strength at least 660 N/square mm, elongation at least 15.5%, hardness not more than 26 HRC, impact notch ductility at room temperature in accordance with ISOV of at least 60 Joules, long duration strength tested for more than 720 hours in accordance with NACE-TM-01-77 in a hydrogen sulphide saturated test solution at a load of not less than 80% of said minimum yield strength.

REFERENCES:
patent: 4608101 (1986-08-01), Umemoto

Affiliated with

Also associated with

Rating

Method of making tubular units for the oil and gas industry does not yet have a rating. At this time, there are no reviews or comments for this patent.

If you have personal experience with Method of making tubular units for the oil and gas industry, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Method of making tubular units for the oil and gas industry will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFUS-PAI-O-1929531