Method for injection stretch blow molding of polyethylene

Details Method for injection stretch blow molding of polyethylene Method for injection stretch blow molding of polyethylene

1994-10-18

1997-04-15

Timm, Catherine

Plastic and nonmetallic article shaping or treating: processes

Direct application of fluid pressure differential to...

Differential temperature conditioning

264532, B29C 4964

Patent

active

056206500

ABSTRACT:
A method enabling stretch blow molding in a temperature range preferable for polyethylene and capable of releasing at a surface temperature suited to both releasing of a preform and subsequent stretch blow molding, by disconnecting the core die and the preform in advance by the use of pressure of gas. The injection molding of a predetermined preform involves filling an injection mold with molten polyethylene, releasing the preform from the cavity die and core die of the injection mold while a mouth portion of the preform is held by the lip die, and transferring the preform into a blow die to stretch blow mold into a hollow molded thin wall product. Gas forcibly enters into the boundary of the core die and the preform, before releasing the preform from the injection mold to isolate the inside wall of the preform from the core die. Releasing is effected while the inside of the preform is not completely cooled and is still at high temperature, and in a temperature range in which the surface temperature of the preform right after releasing is 80 to 90 deg. C. The step of stretch blow molding is performed within the time interval before the surface temperature of the preform which is elevated by the internal heat of the preform reaches 120 deg. C.

REFERENCES:
patent: 3979491 (1976-09-01), Zavasnik
patent: 4019849 (1977-04-01), Farrell
patent: 4044086 (1977-08-01), McChesney et al.
patent: 4116606 (1978-09-01), Valyi
patent: 4207134 (1980-06-01), Valyi
patent: 4242300 (1980-12-01), Valyi
patent: 4323340 (1982-04-01), Uhlig
patent: 4356142 (1982-10-01), Germanio
patent: 4376090 (1983-03-01), Marcus
patent: 4473515 (1984-09-01), Ryder
patent: 4615667 (1986-10-01), Roy
patent: 5364585 (1994-11-01), Takeuchi

Affiliated with

Also associated with

Rating

Method for injection stretch blow molding of polyethylene does not yet have a rating. At this time, there are no reviews or comments for this patent.

If you have personal experience with Method for injection stretch blow molding of polyethylene, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Method for injection stretch blow molding of polyethylene will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFUS-PAI-O-358535