Method of assembling a galvanomagnetic sensor in a cavity in a c

Details Method of assembling a galvanomagnetic sensor in a cavity in a c Method of assembling a galvanomagnetic sensor in a cavity in a c

1980-04-25

1982-07-20

Hall, Carl E.

Metal working

Method of mechanical manufacture

Electrical device making

29596, 29832, 310 68R, 318254, H01F 4102

Patent

active

043398758

ABSTRACT:
A Hall generator flexibly held in an aperture of a circuit plate by its contact strips is pressed between a perpendicular elongated flux concentrator with a tapered nose and the center strip of a somewhat resilient flat flux concentrator. A mounting sleeve provides for force-fitting the elongated flux concentrator and for mounting the two flux concentrators in fixed position on the circuit plate on opposite sides thereof. After the elongated flux concentrator is pressed into a position for flushly clamping the Hall generator under the spring effect of at least the flat flux concentrator, the elongated flux concentrator is permanently set with a little adhesive around its upper periphery to insure continuance of the clamping force. The two flux concentrators come quite close to appropriate portions of an external rotor of a brushless d.c. motor.

REFERENCES:
patent: 4099104 (1978-07-01), Muller

Affiliated with

Also associated with

Rating

Method of assembling a galvanomagnetic sensor in a cavity in a c does not yet have a rating. At this time, there are no reviews or comments for this patent.

If you have personal experience with Method of assembling a galvanomagnetic sensor in a cavity in a c, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Method of assembling a galvanomagnetic sensor in a cavity in a c will most certainly appreciate the feedback.

Rate now

Comments { 0 }

Profile ID: LFUS-PAI-O-244855