Plastic and nonmetallic article shaping or treating: processes – Direct application of fluid pressure differential to... – With internal application of fluid pressure
Patent
1997-06-27
1999-03-23
Tentoni, Leo B.
Plastic and nonmetallic article shaping or treating: processes
Direct application of fluid pressure differential to...
With internal application of fluid pressure
B29C 4500, B29D 2200
Patent
active
058855181
ABSTRACT:
A method and system for injection molding plastic articles which utilize a spill area whose volume varies within an article-defining mold cavity. In one embodiment, the volume increases during introduction of pressurized gas into the mold cavity. In another embodiment, the volume of the spill area varies during a plastic injection which fills the mold cavity. A core reciprocally mounted within the mold cavity partially defines the variable volume of the spill area. An air spring is utilized to control pressure on the core which counters the pressure of the plastic at an end face of on the core. In one embodiment, the end face of the core is non-flat to create an area where fluid plastic can exert pressure against the end face within the mold cavity during plastic injection and/or during introduction of pressurized gas.
REFERENCES:
patent: 2331688 (1943-05-01), Hobson
patent: 3044118 (1962-06-01), Bernhardt et al.
patent: 3135640 (1964-06-01), Kepka et al.
patent: 4101617 (1978-07-01), Friederich
patent: 4129635 (1978-12-01), Yasuike et al.
patent: 4136220 (1979-01-01), Olabiai
patent: 4414167 (1983-11-01), Prusak et al.
patent: 4740150 (1988-04-01), Sayer
patent: 5069859 (1991-12-01), Loren
patent: 5098637 (1992-03-01), Hendry
patent: 5252287 (1993-10-01), Fries
patent: 5262105 (1993-11-01), Komiyama et al.
patent: 5304341 (1994-04-01), Shah
patent: 5639417 (1997-06-01), Kaneishi et al.
Magazine "Spritzgiessen von Kunststoffen", 279 Kunststoffberater 28 (1983) Sep. No. 9, Isernhagen, Deutschland.
Melea Limited
Tentoni Leo B.
LandOfFree
Method for injection molding utilizing a variable volume spill a does not yet have a rating. At this time, there are no reviews or comments for this patent.
If you have personal experience with Method for injection molding utilizing a variable volume spill a, we encourage you to share that experience with our LandOfFree.com community. Your opinion is very important and Method for injection molding utilizing a variable volume spill a will most certainly appreciate the feedback.
Profile ID: LFUS-PAI-O-2122349